## since pi3 we are on aarch64
arm_64bit=1

## wait before starting the kernel
boot_delay=3

## bootloader and its' data;
## don't change default values unless you know what you do
# start_file=start4x.elf
# fixup_file=fixup4x.dat


## kernel command line
# cmdline=cmdline.txt

## set device tree parameters and load some DTB blobs
# dtdebug=1
## RPi3
# device_tree=bcm2710-rpi-3-b.dtb
## RPi4
# device_tree=bcm2711-rpi-4-b.dtb
## whether to use GIC-400 interrupt controller on RPi4
enable_gic=1
## enable audio
dtparam=audio=on
## disconnect BT module from UART0 and set up the serial console
dtoverlay=disable-bt
## enable VC4 video
dtoverlay=vc4-fkms-v3d
# dtoverlay=dwc-otg

## serial console ttyAMA0 would appear at GPIO14 (TXD, pin 8)
## and GPIO15 (RXD, pin 10) ground wire is at pin 6
enable_uart0=1
init_uart_baud=115200

## Graphics setup
gpu_mem=32
disable_overscan=1
#hdmi_safe=1
ignore_lcd=1
display_default_lcd=0
hdmi_force_hotplug=1
max_frambuffers=2
#framebuffer_width=1280
#framebuffer_height=720
## 0 - Pri LCD, 1 - Sec LCD, 2 - Pri HDMI, 7 - Sec HDMI
framebuffer_priority=2
## display rotation or flip
## 0        0 degrees (Default)
## 1        90 degrees
## 2        180 degrees
## 3        270 degrees
## 0x10000  Horizontal flip
## 0x20000  Vertical flip
#display_rotate=0

## uncompressed kernel image (arch/aarch64/boot/Image)
# kernel=kernel8.img

## if you _really_ want to use initrd, you must tell the kernel
## its' name, location and size; have fuc^Hn with that! :-)
# ramfsfile=initrd.gz
